LTSP (dhcp3-server)

Imagen de chamo130113
0 puntos

Hola... estoy configurando LTSP 4.2, estoy utilizando ltspadmin y a la hora de habilitar el demonio para el booteo


Do you want to enable the dhcpd daemon (y/n) ? y

le digo que si y me manda lo siguiente, no se a que se deba, cualquiera que sea su comentario se los agradecere. Salu2......


ltspcfg v0.16 The Linux Terminal Server Project (

dhcpd is the daemon that implements the Dynamic Host Configuration Protocol.
This is needed for LTSP workstations to obtain an IP address and other vital
information from the server.

There are 2 main steps to configuring dhcpd:

1) Build the configuration file

2) Enable the daemon to run when the system is booted

Currently, this utility is not a full dhcp configuration tool. It will
only create a sample dhcpd.conf file that can be hand tuned for your
specific needs.

Do you want to enable the dhcpd daemon (y/n) ? y

ltspcfg v0.16 The Linux Terminal Server Project (

Step 2: Enabling the dhcpd daemon

Enabling dhcpd to run can be a really tricky thing.
The dhcpd.conf file and the leases file MUST exist. Figuring out where
the leases file belongs is a challenge, as it seems to be different on
each distro. Also, telling dhcpd which interface to listen on is done
differently for the various distros.

So, we'll do our best to figure it all out.

Checking leases file
Setting dhcpd to listen on primary interface
Configuring dhcpd to start at boot time
Use of uninitialized value in concatenation (.) or string at /usr/sbin/ltspcfg line 1545, <STDIN> line 6.
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
LC_ALL = (unset),
LC_CTYPE = "en_US",
LC_TIME = "en_US",
LANG = "en_US"
are supported and installed on your system.
perl: warning: Falling back to the standard locale ("C").
update-rc.d: error: expected runlevel [0-9S] (did you forget "." ?)
usage: update-rc.d [-n] [-f] <basename> remove
update-rc.d [-n] <basename> defaults|multiuser [NN | sNN kNN]
update-rc.d [-n] <basename> start|stop NN runlvl [runlvl] [...] .
-n: not really
-f: force
.Use of uninitialized value in concatenation (.) or string at /usr/sbin/ltspcfg line 1058, <STDIN> line 6.

Do you want to build a dhcpd.conf file (y/n) ?

Imagen de chamo130113

Por favor ayudenme, no se que hacer.


Imagen de danielsc

Mira lo que pasa es que te esta pidiendo que construyas tu Dhcp, este es el encargado de entregar sus respectivas direcciones IP, Las cuales Pueden ser automáticas dando el rango o fijas. Ademas configura tu sub red ltsp, te recomiendo que mires en: Ltsp

sigue el link ThinClientHowto mira la parte del Dhcp.

Pero mejor que esto eliminar los paquetes instalados, ir a:

Sigue el link UbuntuLTSP/LTSPQuickInstall

Suerte ...